Ahmad Rifai Masykur Weblog

assalaamualaikum…..

BONGKAR PASANG LAPTOP YUUK..

In this guide I show how to disassemble an Acer Aspire 5610z laptop (also says Model BL50 on the bottom).

Most likely this guide will work for some other Acer Aspire 56XX laptops. If it fits your Acer laptop, please mention the model number in comments after this post.

 

Before you start, make sure the laptop is turned off and battery removed.

STEP 1.

Remove eight screws securing the memory and hard drive covers on the bottom. Remove both covers.

There is one more cover and in my laptop there is nothing under it. I called it Blank cover and removed it too.

STEP 2.

When all covers removed, you can access both memory (RAM) modules, hard drive assembly, cooling fan, wireless card, heat sink and CPU.

In the following steps I’ll remove some of these parts.

STEP 3.

In Acer Aspire 5610z both memory modules can be accessed from the door on the bottom.

In order to remove the memory module, carefully spread latches on both sides of the memory slot. After the memory module pops up at a 30 degree angle, carefully pull it from the slot by the edges.

Use same steps to remove the second module.

You can install up to 2GB RAM in this laptop. Each slot can take up to 1GB RAM module. Use DDR2-533 SODIMM memory modules.

STEP 4.

Slide the hard drive assembly to the right and disconnect it from the motherboard.

Now you can remove the hard drive assemble from the laptop.

STEP 5.

If you are replacing the hard drive, you’ll have to transfer the caddy to the new drive.

Simply remove two screws from each side of the caddy and separate it from the hard drive.

As you see, this is a regular 2.5″ SATA hard drive.

Any 2.5″ SATA hard drive should work fine in Acer Aspire 5610z laptop.

STEP 6.

Remove one screw securing the DVD drive.

Slide the DVD drive to the left and remove it from the laptop.

STEP 7.

Remove two screws securing the cooling fan.

Disconnect the cooling fan cable from the motherboard.

STEP 8.

Now you can remove the fan.

If the cooling fan and heat sink clogged with dust, blow it off with compressed air.

Here you can find a new replacement cooling fan for Acer Aspire 5610z laptops.

STEP 9.

Carefully disconnect both antenna cables from the wireless card.

STEP 10.

Remove the wireless card same way you removed memory modules.

KEYBOARD REMOVAL INSTRUCTIONS.

In the following seven steps I explain how to remove the laptop keyboard.

In order to remove the keyboard it’s not necessary to go through steps 1-10.

STEP 11.

Lift up the right side of the power button board/hinge cover. I’m using a guitar pick.

Continue removing the cover with your fingers.

STEP 12.

The cover has been removed.

STEP 13.

Remove two screws securing the keyboard.

STEP 14.

Lift up the top side of the keyboard and carefully remove it from the laptop.

The keyboard still connected to the motherboard.

STEP 15.

Now you can access the keyboard cable connector underneath the keyboard.

STEP 16.

In order to unlock the connector you’ll have to move the brown clip about 2-3 millimeters towards the laptop display.

The brown clip MUST stay attached to the white connector base.

On the following picture the connect is shown in the unlocked position. Do not move the brown clip any further.

STEP 17.

When the keyboard connector is unlocked, you can release the cable and remove the keyboard.

Looking for a new replacement keyboard? Here are new keyboards for Acer Aspire 5610z laptops.

On the following picture you see the laptop with keyboard removed.

In order to remove the display panel you’ll have to disconnect the video cable and remove four screws securing the display hinges.

In one of the previous guides I posted instructions for removing LCD screen from an Acer Aspire 5100 laptop.

I think you can use those instructions for removing the LCD screen from an Acer Aspire 5610z laptop.

SOURCE: INSIDEMYLAPTOP.COM

11 responses to “BONGKAR PASANG LAPTOP YUUK..

  1. Vandawamb Januari 26, 2011 pukul 2:17 pm

    perlu memeriksa:)

  2. Febri Cutzyourock Juli 31, 2011 pukul 9:52 am

    kalau cara bongkar pasang laptop acer aspire 4732Z gimana gan….
    soalnya punya saya sudah banyak debu didalamnya n kinerjanya agak lemah/sering hang..
    thanks

  3. mimi November 16, 2011 pukul 8:50 am

    kalo bongkar pasang leptop accer aspire 5050 gmna gan,,??
    mohon di jawab secepatnya ya.. :)

  4. www.dhafirshabit@yahoo.com November 22, 2011 pukul 5:55 pm

    kalo buka atau liat konektor cargel dari step mana? apakah senuanya harus di bongkar.aku punya laptop tosiba konektor sepertinya adayang lepas didalamnya kalo dicasnya sambil dipegangin laptop mau nyala tapi kalo dilepas mati.aku uadah sampai kebandung belum ada yangf mampu, habis builup sih jadi penasaran ingin buka sendiri

    • y2k11 Desember 4, 2011 pukul 8:16 pm

      iya..toshiba memang sering banget kendor konektor charger nya…buka aja semua terus solder ulang,,nggak susah kok asal sabar dan teliti…

  5. ipun Juli 10, 2012 pukul 8:37 am

    Ipun. saya punya laptop acer typenya lupa thn pembelian 2004, kl mo ganti jack konector dc nya gimana ya gan, soalnya tonjolan yg ada di jack konector dc patah, ketinggalan di jack changer kira2 sulit gak ya.. mohon penjelasan

  6. baktiar November 18, 2012 pukul 5:54 pm

    gan kalo laptop acer aspire 5050 sering bgt not responding jika di pakek….
    kira2 gmn bgian kerusakan n solusinya gan…
    thanks…

  7. adinatha Juli 20, 2013 pukul 7:47 am

    eh gak ada tutorial merakit notebook asus x43u gak?????

  8. wahono Oktober 19, 2013 pukul 10:10 pm

    wahabi so nyunahhhhhhhhhh……. balatentara yahudi

Tinggalkan Balasan

Isikan data di bawah atau klik salah satu ikon untuk log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Logout / Ubah )

Twitter picture

You are commenting using your Twitter account. Logout / Ubah )

Facebook photo

You are commenting using your Facebook account. Logout / Ubah )

Google+ photo

You are commenting using your Google+ account. Logout / Ubah )

Connecting to %s